On 05/26/2011 04:22 PM, jhallett(a)mindea.com wrote:
Andreas,
I followed your instructions.
~$ ifconfig readout for eth0 is lacking the "inet addr:" line. It DOES
show "inet6 addr:" line.
The section for lo (loopback) correctly shows "inet addr: 127.0.0.1..." as
well as "inet6 addr:" line.
So it appears eth0 is configured only for IPv6 and not IPv4? How would I
fix this?
Did you specify the IP address manually or are you using DHCP? If using
DHCP can you try to setup the IP address manually (Config -> Network)?
Kind regards,
Martijn
--
Djigzo open source email encryption